Operating Your Air Conditioner; Starting Your Air Conditioner - Whirlpool ACQ052PK0 Manual De Uso Y Cuidado E Instrucciones De Instalación

Operating Your Air Conditioner

Operating your air conditioner properly helps you to obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
• If you turn the air conditioner off, wait at least 3
minutes before turning it back on. This prevents the air
conditioner from blowing a fuse or tripping a circuit
breaker.

Starting your air conditioner

Press Power ON/OFF to turn on air
conditioner. When air conditioner is turned on
for the first time after it is plugged in, it will
display the default settings: COOL mode, FI fan
speed, 72°. When it is turned on all other times, it will
display the previous settings.
TEMPERATURE SELECTION
Press to raise the temperature. Each
time you press , the temperature will
go up 1° until it reaches 86°F.
Press to lower the temperature. Each time you
press , the temperature will go down 1° until it
reaches 60°F.
POWER SAVER
Press POWER SAVER ON/OFF. Fan
runs only when cooling is needed. Fan
stops running when the room temperature matches
the set temperature.
MODE SELECTION
Press MODE until you see the indicator
light come on for the setting you want.
Choose FAN or COOL.
COOL – Cools room. You can then adjust
temperature by pressing
fan speed by pressing Fan Speed
FAN – Only the fan runs. Display shows "F1, F2 or
F3" (fan only).
4
or . You can select
• Do not try to operate your air conditioner in the cooling
mode when outside temperature is below 65°F (18°C).
The inside evaporator coil will freeze up and the air
conditioner will not operate properly.
TIMER
The TIMER can be set for a delay from 1
to 12 hours until the air conditioner turns
on or off.
To set the delay TIMER to turn the air
conditioner off, air conditioner must be in
the ON mode. To set the TIMER:
Press TIMER ON/OFF.
Press TIMER ON/OFF to change delay time (from 1
to 12 hours).
Press TIMER ON/OFF, or wait 10 seconds. (Light
will remain on.)
To set the delay TIMER to turn the air conditioner on,
air conditioner must be in the OFF mode. To set the
TIMER:
Press TIMER ON/OFF.
Press TIMER ON/OFF to change delay time (from 1
to 12 hours).
Press TIMER ON/OFF, or wait 10 seconds. (Light
will remain on.)
If you want to change the previous settings:
Turn air conditioner on.
Adjust MODE to FAN or COOL.
Adjust FAN SPEED to F1, F2 or F3.
Adjust TEMPERATURE between 60°F and 86°F.
Turn air conditioner off.
Press TIMER ON/OFF.
Press TIMER ON/OFF to change delay time (from 1
to 12 hours).
Press TIMER ON/OFF or wait 3 seconds.
If you want to keep the previous settings:
Turn air conditioner off.
Press TIMER ON/OFF.
Press TIMER ON/OFF to change delay time (from 1
to 24 hours).
Press TIMER ON/OFF or wait 10 seconds.
To clear DELAY TIMER program, press TIMER until
display reads "0". Indicator light will shut off. Air
conditioner can be either on or off.
To see the remaining time (in hours), press TIMER
once after it has been programmed. While the display
is showing the remaining time, you can press TIMER
ON/OFF to increase or decrease the time.