Samsung LN-S2641D Manual Del Usuario página 19

Setting Up
Your Remote Control
AfTer it has been set up properly, your remote control can operate in five different modes: TV, VCR, Cable, DVD, or Set-Top Box.
Pressing the corresponding button on the mmole contmt allows you to switch between these modes, and control whichever piece of
equipment you choose.
> The remote control might not be compatible with all DVD Players. VCRs, Cable boxes, and Set-Top Boxes.
gigD
:i
(7 (7 (7 ©
655
EZ_ EZ3 EZ_ _
Setting Up the Remote to Operate Your VCR
1. Turn off your VCR.
2. Press the VCR button on your TV's remote controh
3. Press the SE 1' button on your TV's remote control.
4. Using the number buttons on your remote conlrol, enler three digits of the VCR code listed on
page 19 of this manual for your brand of VCR. Make sure you enler three digits of the code,
even if the fir,st digit is a "0". (if morn than one code is listed, try the fir,st one.)
5. Press the POVVER _ button on the remote control. Your VCR should turn on if your remote is
set up correctly.
if your VCR does not turn on after set-up, repeat sleps 2, 3 and 4, but try one of the olher codes
listed for your brand of VCR. if no olher codes am listed, try each VCR code, 000 through 080.
Note on Using Remote Contmt Modes: VCR
When your remote control is in "VCR" mode, the "_olumebuttons still control your TV's volume.
6 5 5
EZ2] EZ_ EZZ] _
_AMSUNG
Setting Up the Remote to Operate Your Cable Box
1. Turn off your cable box.
2. Press the CABLE button on y ..............................................................................................
3. Press the SEI' button on yourTV's remote control.
4. Using the number buttons on your remote control, enter three digits ol the cable box code
listed on page 20 of this manual for your brand ot cable box. Make sure you enter throe digits
of the code, even if the first digit is a "0". (if more than one code is listed, try the first one.)
5. Press the P()WER¢3 button on the remote control.
Your cable box should turn on if your remote is set up correctly.
if your cable box does not turn on after set-up, repeat steps 2, 3 and 4, but try one of the other
codes listed for your brand of cable box. if no other codes are listed, try each code,
000 through 046.
Note on Using Remote Control Modes: Cable Box
When your remote control is in "CATV" mode, the volume buttons still control your TV's volume.
English- 17