Campbell Hausfeld AC080100 Instrucciones De Funcionamiento Y Manual De Piezas página 7

ASSEMBLY INSTRUCTIONS
Handle Assembly (Figure 1)
1. Place ends of handle around tank and into the
mounting pipe. Align holes in handle to holes
in mounting pipe.
2. Assemble four (4) screws (from parts package)
through holes in mounting pipe and handle.
Tighten screws.
Only use the handle to lift one end so the wheels may be
used to move the unit.
Wheel Assembly (Figure 2)
Wheel assembly kit includes:
- 2 wheels *
- 2 axle bolts *
- 2 washers *
- 2 nuts *
- 2 wheel caps*
The items marked with an asterisk (*) were shipped
loose with the unit.
1. Wheel has an offset hub. Place wheel insert
into center of hub. With offset hub facing axle
iron, assemble axle bolt through washer and
then holes in wheel and axle iron.
2. Place lock washer on axle bolt. Then tighten
nut securely to threaded part of axle bolt.
3. Repeat procedure with other side.
Never use the handle to lift the
unit completely off the ground.
5
Handle
Nut
Washer
Bolt
Figure 1 - Handle Assembly
Washer
Figure 2 - Wheel Assembly
Wheel
Nut
Bolt
Cap