Lorex L15LD420 Serie Manual De Instrucciones página 54

Connecting PTZ Cameras - Appendix #5
STEP 4: Secure the Hard Drive in the Casing
This step is vital for the SATA Hard Drive to connect to the DVR.
• Use the 4 provided screws
• Positioning the Hard Drive into place
• Tighten the 4 screws on the bottom of the Casing
NOTE: Insure to use the correct screws.
STEP 5: Slide the top Cover over the Cartridge Casing
• Slide the Cover forward over the Cartridge Case. Ensure it is secured in place over the release
Release Latch
STEP 6: Reinsert the Cartridge Casing into the DVR
• Fully insert the Cartridge Case into the DVR.
NOTE: If the Cartridge Casing is not going all the
way in, gantly adjust the angle of the cartridge
Casing to help line it up to the connectors in the
DVR.
STEP 7: Lock the Cabinet
Lock the cabinet by turning the key clockwise.
NOTE:
If you do not lock the cabinet, the system will NOT DETECT THE HARD DRIVE and will not
function properly. Refer to the Side Panel (Removable Hard Drive Cartridge) on page 12 for
lock location.
54
Position Hard Drive and secure with
latch.
Unlocked
Locked
provided screws