Optika OPTIKAM B1 Guía Usuario página 2

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

Optikam B1/B3/B5/B9 and Optika VisiOn LitE
1.0 instaLLatiOn Of camEra driVErs and sOftwarE
1.1
Operating system requirements: Windows XP, Windows Vista or Windows 7. If your PC is
Windows XP: before the installation of your Camera please check if Service Pack2 is instal-
led. If not, please update your XP from the Microsoft web site. If your PC has a USB port less
than 2.0, there may be some problems in capturing image from the camera due to the slow
transmission.
1.2
Please insert your CD and run:
\ vision lite \ setup.exe
1.3
Now Optika Vision Lite icon appears on your desktop.
1.4
Choose from the folder "\drivers" the model of camera you want to use and select the file
"setup.exe".
1.5
The installer may show warnings about missing Windows certification: ignore such warnings
and select "Continue". Note : do NOT cancel the installation.
1.6
At the end of the installation process restart the PC if requested.
1.7
Plug the Camera in your PC: the camera will be identified and Windows will recognize the
driver which has just been installed from the CD.
Then ignore any message about Windows compatibility and select "Continue" .
Note : do NOT cancel the installation.
1.8
At the end of the identification process, disconnect your Camera and try to plug it again, in
order to check if the Driver was installed correctly (no Windows error messages should ap-
pear).
Should any error message appear on your PC, you will find a "\Troubleshooting" folder on
your CD which shows how to solve any problem which Windows could give.
2.0
sOmE nOtEs
You should know that your Windows PC needs to install a Driver before capturing images
from the camera: after installing the driver from the CD, Windows needs to recognize the
camera before using it.
Page 2

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Optikam b3Optikam b5Optikam b9Optika vision lite

Tabla de contenido