Optika OPTIKAM B1 Guía Usuario página 3

Optikam B1/B3/B5/B9 and Optika VisiOn LitE
Often a PC has some ports on the front and some on the back: the ports on the back are
usually faster. We suggest to use these ones.
All our cameras, even though they may have an external connection, do not need any ex-
ternal power supply because it comes from the USB cable of your PC.
If you connect the camera into another USB port, Windows needs to recognize its Driver
again even if it has alredy done this operation for the first USB port.
Generally, every time you use a peripheral device and after that you connect your Camera,
then Windows needs to recognize the Driver again.
It may happen sometimes that Windows doesn't recognize a Camera using one of your PC
USB ports, while gives no problem using another port.
To prevent any installation problem we have put on the CD all the software and drivers in
specific folders with an appropriate names.
3.0 HOw tO tEst yOur camEra
In order to check if your Camera works correctly, it's not necessary to put it into the microsco-
pe: it's enough to connect it into the USB port, run Vision Lite using the icon on your desktop,
select the right driver and check whether the shown image is not totally black.
4.0 sELEct tHE riGHt driVErs
It's very easy :
For Optikam B1 Camera you have to select the driver :
OPTIKA TCA 1.1
For Optikam B Camera you have to select the driver :
OPTIKA TCA .0
For Optikam B5 Camera you have to select the driver :
OPTIKA TCA 5.0
For Optikam B9 Camera you have to select the driver :
OPTIKA TCA 9.0
To use Optika Vision Lite you have to tell the Software which is the Driver by selecting the
microscope-shaped icon.
Page