AL-KO Solo 532 Manual Del Usaurio página 13

MAINTENANCE
For changing the oil and other maintenance operations on the motor (spark plugs, air filter, regulations), refer to the motor
manual provided.
Make a regular check of the oil level in the gearbox with the cap (Fig. 12 Ref. "B") and topping up if necessary.
Change the oil completely every 200 hours. Empty the gearbox of oil by unscrewing the oil drain plug (Fig. 12 Ref. "C")
Allow oil to flow out completely. Then, unscrew the plug completely, and fill with new oil of the recommended type,
unscrewing breather plug (Fig 12 Ref. "A"), up to the correct level - see the screw (Fig 12 Ref. "B").
If the grass is not cut in a satisfactory manner despite the adjustments, the blade must be sharpened or replaced. Follow
the instructions on the E.S.M. maintenance sheet.
For any mechanical repair, especially during the warranty period, we recommend to go to a specialised repair shop of the
dealer.
For transporting convenience, the handles can be disassembled by means of the two knobs (Fig. 10 Ref. "A"). The same is
recommended for the cutting bar, which is easily disassembled by after moving the locking knob (see Fig. 5). Always use
gloves and apply the protective strip to the blade.
Regularly check that screws are tight. Pay special attention to the screws fastening the bar to its support.
In the types with air filter in oil bath check the oil and clean the filter box every 10 working hours (see Fig. 14).
IMPORTANT: Working whit the machine for a longer time you should use ear
protection system.
Fig. 12
A
B
C
13
Fig. 14
EN