Switching On - Vetus CCM Manual De Manejo Y Instrucciones De Instalación

4.2 Switching on

Switch on the instrument using an external switch
(there is no ON/OFF switch on the instrument).
The start up screen will be displayed for a few sec-
onds.
The main screen will be displayed after the start up
screen.
1 Status bar - displays the status of the instrument
and any error message.
2 Chain speed - displays the chain speed while
raising or lowering.
3 Units for chain speed,
mt/m - metres per minute
ft/m - feet per minute
4 Chain counter - displays the length of chain paid out.
5 Units of chain counter,
m - metres
ft - feet
6 Control bar - displays the voltage (V = .. V) and current (I = .. A).
7 Icons - show raising or lowering the anchor, or an error message.
The following factory settings are made when the instrument is used for the first time:
English
Reset Meas.
Units
Rope-Chain
Up Alarm
Auto Down
Lite Time
Keyb. Beep
Language
Sensor Detect
Barb. Circ.
Overcurrent
Wire Diam.
Work Hours
Control panel / chain counter CCM
DO NOT USE
DO NOT USE
vetus
Chain Counter
1
Stop
2
0.0 mt/m
0.0
4
V=11.6
6
Default
0.0 metres
meter/centimeter
Off
3.0 metres
Off
30 seconds
Yes
Italian
onknown
30 cm
Off
1.20 cm
0 hours
ENGLISH
7
3
m
5
I=0.0
Change, reset
see 5.1.1
see 5.1.2
see 5.1.3
see 5.2.1
see 5.2.2
see 5.3.3
see 5.3.4
see 5.4.1
see 5.5.1
see 5.5.2
see 5.6.1
see 5.6.2
see 5.7.4
21
060123.01