Menu Item 'Current Calibration - Vetus CCM Manual De Manejo Y Instrucciones De Instalación

In order to obtain a correct reading the instrument must be set for the gipsy used. The
reduction factor must be entered in order to do this.
The reduction factor (Proj. factor) must now be set.
See the table for the correct reduction factor to use.
Napoleon gipsy 1
Napoleon gipsy 2
Napoleon gipsy 3

5.6 Menu item 'Current calibration'

5.6.1 Overcurrent
The function 'Overcurrent' is used to set an alarm for a
particular current value (in A).
The beep will sound and the status bar will show
'Overcurrent' when the set current value is reached.
Range: Off, 1 - 200 A
5.6.2 Wire diameter
The function 'Wire diameter' is used to enter the diameter of the main power cables (includ-
ing insulation).
Range: 0.01 - 0.02 - 0.03 - .. - 6.00 cm
This function is necessary to allow the current sensor to work properly.
5.6.3 Exit
Function 'Exit' is used to return to the menu.
Control panel / chain counter CCM
Chain
8 mm
10 mm DIN766, 3/8" BBB
10 mm ISO4565, 3/8" HT
ENGLISH
Sensor Calibrat
Pr oj. Fac t or
Ex i t
Reduction factor
57
59
Current Calib.
Ov er c ur r ent
W i r e D i a m .
Ex i t
060123.01
5 7 . 0
Off
1 . 2 0
25