Charge The Battery; Switch The Device On Or Off; Phone Setup Application; Access Codes - Nokia 6790 Surge Guia Del Usuario

■

Charge the battery

Your battery has been partially charged at the factory. If the device indicates a low charge,
do the following:
1. Connect the charger to a wall outlet.
2. Connect the charger to the device. The
charging port is behind the black
cover.
3. When the device indicates a full
charge, disconnect the charger from
the device, then from the wall outlet.
You do not need to charge the battery for
a specific length of time, and you can use the device while it is charging. If the battery is
completely discharged, it may take several minutes before the charging indicator appears on
the display or before any calls can be made.
■

Switch the device on or off

Press and hold the power key.
If the device asks for a PIN code, enter the
PIN code, and select OK.
If the device asks for the lock code, enter
the lock code, and select OK.

Phone setup application

The Phone setup application starts when
you switch on your device for the first time.
With the Phone setup application, you can
customize how the device looks and works.
To open Phone setup later, select
Settings > Phone setup.
Set time and date
To set the correct time zone, time, and date, select the country you are presently in, then
enter the local time and date.
Some networks automatically update the time and date. For information on this feature,
contact AT&T.
■

Access codes

To set how your device uses access codes, select
Security > Phone and SIM card.
12
>
> Settings > Config. > General >