Unlatching & Raising The Cutting Head - Evolution R185SMS Instrucciones Originales

www.evolutionpowertools.com
RESETTING THE LOCATING LUGS
• Gently push the protruding lug into the
Carriage arm.
• Gently ease the locating lug deployment plunger
forward by using a flat bladed screwdriver (not
supplied) as a lever. (Fig. 9)
The carriage slides two (2) arms should be inserted
through the two linear bearings contained within
the bevel neck.
The carriage slide should be inserted from the back
ensuring that the 'Evolution' logo is the correct way
up. (Fig. 10)
• Slide the sliding carriage arms through the bevel
neck for approximately half of their length.
• Screw the carriage slide locking screw into the
threaded hole above the right hand arm of the
carriage slide. (Fig. 11)
Note: Ensure that the anti-vibration spring is fitted
underneath the hand knob before fitting the
locking screw into its service position.
• Tighten the locking screw to lock the sliding
carriage into the desired position.
ATTACHING THE CUTTING HEAD
• Align the cutting head with the two (2) sliding
carriage arms. (Fig. 12a)
• Push the cutting head onto the Carriage arms
firmly until the 'click' of the Locating Lugs
deploying is heard. (Fig. 12b)
Note: The deployed locating lugs must be fully
visible when viewed from the side of the cutting
head. (Figs. 13a, 13b, 13c)
The Locating Lugs are coloured green to make
identification easy.
THE MACHINE TABLE EXTENSIONS (Fig. 14)
Note: Two (2) machine table extension pieces are
provided with this machine.
TO FIT THE TABLE EXTENSIONS:
• Remove the socket headed screws (Fig. 15) from
the table using the hex key provided.
• Position the relevant Extension piece onto the
table and secure it into its service position using
the socket headed screws.
• Repeat for the second Extension piece.
ROUTING THE POWER CABLE
WARNING: This machine is equipped with a mains
cable and a moulded plug which satisfies the
regulations of the receiving country. This cable and
plug, if damaged, should only be replaced with
genuine Evolution replacement parts and be fitted
by a competent technician.
• Ensure that the cutting head is in the
down position.
• Ensure that the carriage slide is in its most forward
position and locked. (Fig. 16)
From the motor the mains cable should bypass the
front cable guide and then be routed rearwards
(Fig. 17).
The cable should be inserted into the rear cable
guide/clamp. Ensure the Cable Grip Component
is inside the cable guide when the cable
passes through.
This guide/clamp should then be fastened to the
rear sliding carriage cross piece (right hand side)
using the self tapping cap screw (included).
(Fig. 18)
Note: The cable should not be tight anywhere
along its length. (Fig. 19)
Raise and lower the cutting head several times
and also operate the sliding carriage. Check that
the cable does not become entangled with any
other parts of the machine. Check also that the
cable is not stretched during any of the operating
procedures. Secure the cable using the cable clip.
Note: The cable clip can be used to prevent the
cable becoming loose during storage or transport.
(Fig. 20)
UNLATCHING AND RAISING
THE CUTTING HEAD
(Fig. 21)
WARNING: To avoid serious injury, NEVER
perform the locking or unlocking procedure
unless the saw is OFF and the blade stationary.
To release the cutting head from the locked down
position:
• Gently press down on the Cutting Head Handle.
• Pull out the head latching pin (Step 1) allow the
cutting head to rise to its upper position. (Step 2)
23
EN
DE
ES
FR
PL
PT
RO