Compound Cutting; Crown Moulding Cutting; Cutting Bowed Material; Clearing Jammed Material - Evolution R185SMS Instrucciones Originales

Ocultar thumbs Ver también para R185SMS:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

www.evolutionpowertools.com

COMPOUND CUTTING

(Fig. 60)
A compound cut is a combination of a mitre
and bevel cut employed simultaneously. When
a compound cut is required, select the desired
bevel and mitre positions as previously described.
Note: Compound Cutting with the sliding
carriage system deployed is possible.
Always check that the sliding blade does not
interfere with the machines fence or any other
parts of the machine. Adjust the upper left hand
section of the sliding fence if necessary.

CROWN MOULDING CUTTING

This machine is capable of cutting the mitre
angles required for Crown Mouldings. To
configure the machine to cut Crown Moulding:
• Deploy the 33.9˚ Bevel Pin by pushing it fully
inwards. (Fig. 57)
• Tilt the cutting head to the 33.9˚ position and
lock it in place by tightening the bevel lock
handle.
• Turn the rotary table and set it to 31.6˚ mitre
angle as indicated by the protractor scale.
Ensure that the Crown Moulding is correctly
positioned on the rotary table and secure it with
appropriate clamps before making the cut.
When cutting operations are completed, return
the cutting head to the vertical position and
return the 33.9˚ Bevel Pin to its outer (disengaged)
position.

CUTTING BOWED MATERIAL

WARNING: Before cutting any work-piece, check
to see if it is bowed. If it is bowed the work-piece
must be positioned and cut as shown.
Do not position the work-piece incorrectly or cut
the work-piece without the support of the Fence.

CLEARING JAMMED MATERIAL

• Turn mitre saw "OFF" by releasing the
trigger switch.
• Allow the blade to come to a complete halt.
• Unplug the mitre saw from the mains supply.
• Carefully remove any jammed material from
the machine.
• Check the condition and operation of the
safety guard.
• Check for any other damage to any part of the
machine e.g. the blade.
• Have any damaged parts replaced by a
competent technician and a safety inspection
carried out before using the machine again.
The free end of a long work-piece should be
supported at the same height as the machines
rotary table. The operator should consider using
a remote work-piece support stand, adjustable
workmate or saw horse etc.

OPTIONAL EVOLUTION ACCESSORIES

DUST BAG (Supplied with R185SMS+)
A Dust Bag can be fitted to the extraction port at
the rear of the machine. The Dust Bag is for use
when cutting wooden materials only.
• Slide the Dust Bag over the dust extraction
port, ensuring that the spring clip grips the port
holding the Dust Bag securely in place. (Fig. 62)
Note: For operational efficiency empty the Dust
Bag when it becomes 2/3 full. Dispose of the
contents of the Dust Bag in an environmentally
responsible way. It may be necessary to wear a
dust mask when emptying the Dust Bag.
WARNING: Do not use the Dust Bag when
cutting metallic materials including wood
with nails.
EXTRACTION PORT ADAPTOR
TUBE
(Supplied with R185SMS+)
Use the Adaptor Tube to connect the extraction
(Fig. 61)
port of the machine to suitable commercial
workshop vacuum extraction equipment (not
supplied) which have ø30mm internal bore hoses
or inlet ports.
31
EN
DE
ES
FR
PL
PT
RO

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

R185sms+

Tabla de contenido