Mounting The Unit - Klarstein Skyscraper 2G Manual De Instrucciones

EN
12

MOUNTING THE UNIT

1 Carefully remove the appliance from the plastic bag and the carton, and unwind
the cord.
2 Assemble the base of the fan onto the bottom of the body:
A
Remove the 3 thumb screws on the
bottom of the main body.
C
Push the base into the bottom of the
fan body and align the 3 holes. Attach
using the 3 thumb screws.
3 Place the appliance onto a stable, flat and dry surface.
4 Plug the cord set into a 220-240V~A.C. 50Hz earthed electrical outlet. Turn the
power on at the electrical outlet. The blue Power indicator (next to the Power button)
will light up and a beep will sound.
Note: The remote control uses battery. To replace, push clip at bottom of remote
inwards & pull out battery holder, replace battery and push holder back in.
B
Place the power cord between the
two halves of the base and bring them
together (plug end should be on the
side of the base feet).
D
Fix the cord to the underside of the
base in the 2 small clips and through
the slot that exits close to the rear of the
appliance.