Usage Of The Remote Control - Klarstein SKY HIGH Manual De Instrucciones

Wind speed
When this button is pushed, three different wind speeds of low, medium and high can be set.
Oscillation
When this button is pushed, the fan starts to oscillate the wind,by pressing this button
again, the fan stops oscillate the wind.
Notes on Use
• The above operation can also be carried out on the control panel of the fan body,
with the method same as the one described above.
• Only when "ON/OFF" is pushed, the fan can send wind.

USAGE OF THE REMOTE CONTROL

• When the remote control is used, make sure that the head of the front of the remote
control is aligned with the receiving window on the fan body.
• The remote control can be about 5m from the front of the fan body; it can be
normally operated if the deviation is within 30 degrees.
• Avoid direct sunlight on the receiving window, so as not to affect the effect of the
receiver.
• If the remote control is not used for a long time, remove the battery and handle it
properly.
When using the remote control, install the battery. The remote control operates on one
lithium battery, with the insertion method as shown below:
1. Open the battery cover.
2. Insert a new battery, pay attention to the polarity of the battery (+ and -).
3. Close the battery cover.
EN
17