INST LL TION INSTRUCTIONS
If the "slave" channel is combined with the 4-channel contact interface (GW 90 834) the
following functions are proposed on the base unit.
Names of the functions on the Easy base unit
edges
scene
heating mode
Refer to the Easy base unit documentation for further information on the programming
procedures.
SLA (Slave)
This is used to set:
• the timer-thermostat function type and mode with
other KNX/EIB devices from a remote position.
Examples of devices which can be used are the EASY
GSM Remote Control Unit, the EASY control panel and
display, the EASY 4-channel contact interface etc;
• the OFF mode on the timer-thermostat, with priority
over all the other commands, if an open window signal
is received. When the closed window signal is
received, the timer-thermostat returns to its previous
function mode or to the last mode it was in when it
received the forced OFF command;
• memorising the scenes, max 8: the timer-thermostat
memorises the current function type, mode and set-
point.
Edge management command (for window contacts)
Scene management command
Thermal regulation commands (mode)
69
E
N
G
L
I
S
H