Product Description; Installation And Start-Up; Module Configuration; Display Function - Fagor evo PRO 100 Manual De Instrucciones

■ PRODUCT DESCRIPTION

evo
PRO 100 is a programmable unit that includes high selectivity filtering up to 32 channels from
its four VHF / UHF inputs converting them to any output channel. All the output channels are
combined in one equalized RF output that can be amplified to an optimum level for distribution.
As it's provided with an embedded display and key pad, it's appropriated to adjust the channels and
output level at the same installation, to successfully distribute the signals within a multi-dwelling
building.
Main features:
 32 filters of variable bandwidth and high selectivity for the
conversion of the terrestrial TV input channels.
 Internal Pre-Amplifier with Automatic Gain Control (AGC) to
compensate the input signals differences.
 4 VHF / UHF inputs to choose the best input for the input
channel to be processed.
 Automatic selection for 4G and 5G LTE filtering, to minimize the interference of these signals.
 Output level configuration up to 113 dBµV to increase the signal distribution.
 Automatic measurement of the level of the input channels to be processed.
 Auto-Scan: Automatic search of the existing channels in each RF input.
 Channels and output level programming in an intuitive way through key pad and LCD display.
 Possibility of configuring through an Android APP.

■ INSTALLATION AND START-UP

 Connect the equipment ground point to the installation ground point, (6), page 2 Controls.
 Connect the antennae cables to the corresponding inputs and close the free inputs with 75 charges
(Ref. 84011)
 Connect evo PRO 100 to the electrical mains.
 Connect the output cables to the signal distribution network.
 evo PRO 100 is an indoor unit designed to operate in a temperature range of 0~50ºC, but it's
recommended to install the device in a temperature controlled environment to ensure its optimum
behavior and to maximize the product life. Also, it's necessary to not expose the unit to rain or
moisture.

■ MODULE CONFIGURATION

evo PRO 100 can interact with the user in two ways:
 With an Android device connected by USB to the module and using the corresponding APP that can
be checked in the FAGOR website.
 Through the display included in the module that allows checking and modifying its parameters'
configuration. A keypad is also provided with the module, consisting of four buttons with arrows, that
allows the user moving through the configure menu diagrams shown in pages 6 and 7.

Display function

First line indicates the parameter group to
be accessed or the parameter to configure.
Second line shows the parameter to be
accessed or its actual value.
Key buttons functions
The buttons with the up / down arrows allow:
 Choose a parameter group or a parameter.
 Change the value of a parameter.
The buttons with the left / right arrows allow:
 Enter or exit the menu function.
 Move along the characters of a parameter value.
14