Broan 192 Manual Del Usuario página 2

PLANNING
This heater is intended to be used to supply
supplemental heat from a wall location in new or
existing construction.
Choose a location where edge of heater will be
at least 12" from the floor or any adjacent vertical
surface.
The heater can be operated using its built-in ther-
mostat or a remote thermostat (such as the Model
86W Line-Voltage thermostat or an appropriate
low-voltage thermostat and transformer/relay). The
Model 85 Kit is available for surface-mount appli-
cations. Purchase these accessories separately.
Plan to supply the heater with proper line voltage
and appropriate power cable.
NOTE: Power can be tapped from a nearby circuit
depending on the heater wattage required and the
amperage rating of the circuit.
Heater can be converted to half-wattage to avoid
overloading such circuits.
MODEL VOLTS AMPS
192 240 8.33/4.17
194 240 12.50/6.25 3000/1500 10240/5120
198 240 16.67/8.33 4000/2000 13653/6827
Bold ratings are factory wired.
See "OPTIONAL WIRING CONVERSIONS" sec-
tion for wattage conversion instructions.
DRYWALL
THERMAL
OVERLOAD
GRILLE
BUILT-IN
THERMOSTAT
Follow these basic steps when installing this heater:
1) Nail housing to studs.
2) Connect power cable.
3) Fasten heater assembly and grille to housing.
WATTS BTU/HR
2000/1000 6827/3413
HEATER HOUSING
POWER CABLE
MODELS 192 • 194 • 198
Page 2