Broan 192 Manual Del Usuario página 3

INSTALLATION
WARNING: To reduce the risk of fire, do not store or
use gasoline or other flammable vapors and liquids
in the vicinity of the heater.
CAUTION: High temperature, risk of fire, keep elec-
trical cords, drapery, furnishings, and other com-
bustibles at least 3 feet (0.9 m) from the front of the
heater and away from the side and rear.
HEATER
ASSEMBLY
MOUNTING
SCREWS
1. Remove heater assembly from housing. Take out the
four (4) screws shown and set heater assembly aside.
NAIL HERE –
BOTH SIDES
2. Attach housing to wall studs.
NOTE: Locate housing at least 12" from floor on any
adjacent walls.
Use the measuring guides on the sides of housing to
position housing so that it will be flush with finished wall.
Nail the housing to studs through the hole and slot on
both sides of housing.
NOTE: In 24"-on-center stud construction, framing in
between studs is necessary.
THERMAL
OVERLOAD
"RESET"
BUTTON
THERMOSTAT
MEASURING
GUIDES
MODELS 192 • 194 • 198
Page 3