Click 2 Setting - Weinmann CPAP 20e Descripción Del Aparato E Instrucciones De Manejo

4.2 CLICK 2 setting

Switching on the humidifier
1. Fill up the humidifier and set up as described in "3.2 Filling and connecting the
CLICK 2" on page 16.
2. Switch on the therapy unit.
Humidifier button
Setting the heating level
1. Make sure your therapy unit is switched on.
Humidifier button
Which is the best setting for you will depend on the room temperature and the
air humidity. The optimum setting will therefore vary depending on the time of
year. Under normal conditions heating level 3 is sufficient.
If the temperature is 23 °C and air humidity 70 %, a humidity of 100 % can be
reached with heating level 6 and a flow rate of 20 l/min.
If your airways are dry when you wake up, the heating level is too low. Select a
higher setting.
If condensation forms in the breathing hose during a night therapy session, the
heating level is too high. Choose a lower heating level.
3. Press the humidifier button
unit. The humidifier symbol
cation level display (level 4 in this case) are
shown in the display of the therapy unit.
2. Press the humidifier button
onds until the number and the humidifier sym-
bol start to flash.
3. Release the humidifier button
4. Now select the heating level (1-6) using the on/
off switch (+) or the softstart button (-).
The displayed value is saved after 4 seconds.
of the therapy
and the humidifi-
for approx. 3 sec-
.
EN
Operation
21