Operation; Cpap 20E Startup; Put On The Mask - Weinmann CPAP 20e Descripción Del Aparato E Instrucciones De Manejo

4. Operation

4.1 CPAP 20e startup

Warning! Risk of injury!
Never place the breathing hose around your neck.
Switch on the device
1. Press the on/off switch.
The therapy period will appear for approx. 3 seconds in the display. The flow
generator starts to convey air through the breathing hose.
If softstart has been preselected, the softstart display will then light up and the
softstart time will appear in the display.
CPAP 20e is now ready for operation.
Note:
If the device is not used for 15 minutes, it will automatically switch off (only
if the therapy pressure is higher than 6hPa).
EN
20
Operation

Put on the mask

1. Put on the mask as described in Section "3.3
Breathing mask" on page 17.
2. Connect the breathing hose to the mask (plug
cone).
3. Feed the breathing hose away from your head.