Install Base Grille; Complete Installation - JENN-AIR JF42NXFXDW Manual De Instalación

3. Depending on your model and the compartment, rotate the
plastic spacer so that the curved handle mounting posts are
either at the top, bottom or to the left. See following chart.
Bottom Mount
Refrigerator
Left Right
Swing Swing
Curved Bottom
Mounting
Post
Setscrews Right
4. Slide the screw into the handle mounting stud. Insert the
screw assembly into the center hole of the plastic spacer and
fasten it to the door panel.
5. Install the handles to the handle mounting studs so that the
setscrews are on the designated side and tighten the
setscrews.

Install Base Grille

There are two pieces to the base grille to allow for a custom fit: the
base grille itself and the skirt. The skirt can be added to the base
grille in order to extend it all the way to the floor.
1. To see whether the skirt is needed, place the base grille into
position. Do not attach the base grille to the refrigerator.
Measure the distance between the bottom of the base grille
and the floor. The gap must be a minimum of ¹⁄₂" (1.27 cm) in
order to add the skirt.
NOTE: If the gap measures less than ¹⁄₂" (1.27 cm), skip
steps 3 and 4 of the instructions, and install the base grille
only.
2. Remove the film from the base grille.
3. Snap the skirt onto the base grille.
A. Base grille
B. Skirt
French Door
Bottom Mount
Refrigerator
Left Right
Door Door
Top Bottom Top
Left Right Left
A
B
4. Trim the skirt by scoring the proper "V" groove with a utility
knife. Break the skirt at the score line.
Both
Models
Freezer
Drawer
5. Using the two screws, attach the base grille assembly to the
Left
refrigerator as shown.
NOTE: Drive in the right side screw first.
Down
1. Turn the water supply line valve to the "Open" position.
2. Turn the refrigerator switch to the ON position. See "Power
On/Off Switch" in the Use & Care Guide for instructions. Wait
a few minutes. Check the water line connections for leaks.
3. Remove all boxes, parts packages and packing materials from
the interior of the refrigerator. See the "Cleaning" section in
the Use & Care Guide for instructions. Remove the film and
cardboard from the grille and doors or door frame, depending
on your model.
4. Install the shelves and bins in the refrigerator and freezer
compartments.
5. The controls are preset at the factory to the midpoint setting.
Check that the compressor is operating properly and that all
the lights are working.
6. Flush the water system before use. See "Water System
Preparation."
To get the most efficient use from your new built-in refrigerator,
read the Use & Care Guide. Keep Installation Instructions and Use
& Care Guide near the built-in refrigerator for easy reference.
A. "V" groove
A
A. Screws (2)

Complete Installation

27