Power Supply Operation And Safety; Charging Procedure; Important Charging Notes - Stanley Fatmax FMHT77356 Manual De Usuario

• Please read all related instructions and warnings
in the accompanying Battery Safety and Laser
Safety/Warranty manuals. Follow all local
regulations for disposal of the product at the
end of its life.
Power Supply Operation and
Safety
Important Safety Instructions for Power Power supply/
Supply.
SAVE THESE INSTRUCTIONS:
Your tool uses a power supply operating between
100-240V AC @50/60Hz.
Before using the power supply, read all safety
instructions and cautionary markings on power supply,
and product before using your power supply.
WARNING: Shock hazard. Do not allow any
liquid to get inside power supply. Electric shock
may result.
CAUTION: Burn hazard.
• NOTICE: Under certain conditions, with the
power supply plugged in to the power supply,
the power supply can be shorted by foreign
material. Foreign materials of a conductive
nature such as, but not limited to, grinding dust,
metal chips, steel wool, aluminum foil, or any
buildup of metallic particles should be kept away
from power supply cavities.
• Always unplug the power supply from the power
supply when not in use. Unplug power supply
before attempting to clean. Clean only with
a soft dry cloth
• DO NOT attempt to charge the product with any
power supplys other than the one provided with
your product. The power supply and integrated
battery pack are specifically designed to work
together.
• The power supply provided with your laser is not
intended for any uses other than charging the
Fatmax laser. Any other uses may result in risk
of fire, electric shock or electrocution. Use only
HUNTKEY Model # HKA03612030-8C
• Store power supply out of reach of children.
• Do not expose power supply to rain or snow.
• Pull by plug rather than cord when disconnecting
power supply. This will reduce risk of damage to
electric plug and cord.
• Do not place any object on top of power supply
that might result in excessive internal heat. Place
the power supply in a position away from any
heat source.
• Do not operate power supply with damaged
cord or plug.
• Do not operate power supply if it has received
a sharp blow, been dropped, or otherwise
damaged in any way. Take it to an authorized
service center.
• Do not disassemble power supply; take it to
an authorized service center if service or repair
is required.
• The power supply is designed to operate on
100-240V AC @50/60Hz.
• Do not attempt to use it on any other voltage.
• Refer to Battery Safety Manual for additional
instructions.

Charging Procedure

1. Plug the power supply into an appropriate
outlet before connecting to laser unit.
2. Insert the charging cable into the charging port
on the rear of the laser unit.
NOTE: A battery pack will slowly lose its charge when
left idle for extended periods of time. The product may
need to be recharged before use.

Important Charging Notes

The power supply may become warm to touch while
charging. This is a normal condition, and does not
indicate a problem. To facilitate the cooling of the
battery pack after use, avoid placing the power supply
or battery pack in a warm environment such as in
a metal shed, or an uninsulated trailer.
If the internal battery does not charge properly:
a. Check operation of receptacle by plugging in
a lamp or other appliance;
b. Check to see if receptacle is connected to a light
switch which turns power off when you turn out
the lights;
c. Move power supply and laser unit to a location
where the surrounding air temperature is
approximately 65 °F - 75 °F (18 °- 24 °C);
d. If charging problems persist, take the tool, and
power supply to your local service center.
7