Error Codes; Locating Your Robot; Starting And Stopping - Philips FC8832 Manual Del Usaurio

English
14
Signal Description of signal
The start/stop button is continuously red.
The start/stop button is continuously red and the
display shows an error code.

Error codes

Error code
E1
E2
E3
E4
E5
E6

Locating your robot

Starting and stopping

Possible cause
Wheels stuck
Top cover or dust
container not placed
properly
Bumper stuck
Robot lifted from floor
Color of floor too dark
Problem with battery
If you do not see the robot, you can locate it by clapping your hands once.
The robot will respond by beeping and by lighting up all icons on its display.
Clap response is enabled when the robot enters sleep mode in the following
situations:
- when it stops cleaning due to an error
- when it is unable to find its docking station within 20 minutes
.
1 Press the start/stop button on the robot or in the app.
Meaning of signal
The rechargeable battery of the robot
is almost empty.
Please consult the error code table
below to understand the meaning of
the error code.
Solution
Remove robot from the obstacle and press the
starts/stop button to resume cleaning.
Place the dust container in and the top cover
on the robot properly. The error code
disappears from the display automatically.
Remove the robot from the obstacle. The error
code disappears from the display
automatically.
Put the robot back on the floor to make the
error code disappear.
Place robot on a lighter area of the floor. Clean
the drop-off sensors.
Please contact the Consumer Care Center to
have the problem examined.