Andis PULSE ZR II Manual De Usuario página 3

14. The battery in this clipper is designed to provide maximum
trouble-free life. However, like all batteries, it will eventually wear
out. Do not attempt to replace battery. When repair or
replacement is required, send or take it to an Andis authorized
service station.
15. Batteries can be harmful to the environment if disposed of
improperly. Many communities offer recycling or battery collection.
Contact your local government about disposal practices in your
area.
16. WARNING: Never touch both terminals on clipper with metal
objects and/or body parts, as short circuit may result. Keep away
from children. Failure to comply with these warnings could result in
fire or serious injury.
17. Keep the appliance dry.
18. WARNING: During use, do not place or leave appliance where it
may be 1) damaged by an animal or 2) exposed to the weather.
19. WARNING: For the purposes of recharging the battery, only use
the detachable supply unit provided with this appliance.
20. WARNING: Cutting blades may become hot after prolonged
21. This appliance is intended for trimming purposes only.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
• The battery must be removed from the appliance before it is recycled.
• The battery is to be recycled as a lithium-ion battery.
UNIVERSAL AC/DC POWER ADAPTER
1 . Remove the wall adapter and charger from the carton.
2. Note the charger comes standard with a universal AC voltage wall adapter and four
interchangeable plugs (Figures A-D).
3. To attach the desired plug to the wall adapter, align the slots on the plug to the ribs on the wall
adapter and slide into place. The plug will "click" into place when properly attached. To remove,
locate the button marked "push" on the wall adapter. Press the button and slide the plug from the
wall adapter. The plugs for the various countries all attach and remove using the same method
(Figure E).
4. Connect the power cord to the back of the charger and then insert the transformer into an
AC outlet.
CHARGING UNIT
To charge, plug wall adapter into 100-240V, 50/60 cycle AC electrical outlet or as noted on the unit.
Make sure the proper input plug is attached to the wall adapter. Plug power cord directly into back of
charging stand. The battery pack may be charged while on the clipper or separately. To charge the
battery pack while in the unit, place clipper into the pocket on the charging stand. NOTE: the clipper
should be charged with the switch in the OFF position. To charge the battery pack separately, remove
the battery pack by pressing the tab on the back of the battery (Figure F), sliding the battery out and
placing in the pocket on the charger (Figure H).
Before using your clipper for the first time, make sure the battery has been fully charged. Note
that it is normal for the clipper and wall adapter to feel warm to the touch when charging. This is
especially true if the battery has been deeply discharged as indicated by the clipper indicator light
turning red (Figure G) while the clipper is running. The clipper should be charged with the switch in
the OFF position.
To start clipper, move power switch to ON position. To stop clipper, move power switch back to
original position (Figure G).
use.
3