Troubleshooting - Bissell PROheat 2X CLEANSHOT 20B4 Serie Guia Del Usuario

Tabla de contenido

Publicidad

T
roubleshooting
Built-in heater ready light does not illuminate
Possible causes
1. The heater switch is not turned ON ( I )
2. The power switch is not turned ON ( I )
Reduce Spray or No Spray
Possible causes
1. Water tank may be empty
2. Formula tank may be empty
3. Tank may not be seated completely
4. Pump may have lost prime.
DirtLifter
PowerBrush does not turn
®
Possible causes
1. The belt is off or broken
2. The unit is in the upright position
3. Circuit breaker on machine may have tripped
Cleaner not picking up solution
Possible causes
1. ReadyTools dial may be at wrong setting
2. Tank may not be seated properly
3. Tank may not be assembled properly
4. Solution or 2-in-1 water tank is empty
5. 2-in-1 water tank has picked up maximum dirty water
and red float door has closed.
6. Red float "door" in the tank may have closed as a result of bumping 6. Turn the machine OFF ( O ), allowing red float door to release
an object or moving machine back and forth too quickly
Other maintenance or service not included in the manual should be
performed by an authorized service representative.
Thank you for selecting a BISSELL product.
Please do not return this product to the store.
For any questions or concerns, BISSELL is happy to be of
service. Contact us directly at 1-800-237-7691.
20
w w w . b i s s e l l . c o m
w w w . b i s s e l l . c o m
Remedies
1. Turn the heater switch ON ( I )
2. Both switches must be ON ( I ) to activate the
heater ready light
Remedies
1. Fill heavy duty bladder with hot tap water
2. Fill formula tank with BISSELL 2X
Formula for cleaning
3. Turn power OFF (0). Remove and reseat tank
4. Turn power OFF (0) and then back ON (I). Wait one minute,
then depress trigger
Remedies
1. Turn power OFF ( O ) and unplug unit from outlet. Follow
instructions on page 19
2. Brushes only rotate when unit is reclined using the
detent pedal
3. Turn the machine OFF ( O ) and unplug from outlet. Check
to see if foreign object is caught in brush roll. Remove
object. Plug machine in to reset circuit breaker
Remedies
1. Set ReadyTools dial to either FLOOR CLEANING or TOOLS setting
2. Pick up both the 2-in-1 water tank and formula tank and
reseat them so they fit snugly on the unit
3. Check to make sure the "lip" of the nozzle is securely
hooked into the groove on bottom of Tank (see page 10)
4. Check fluid levels in heavy duty bladder and formula tank.
5. Empty 2-in-1 water tank. Refill heavy duty bladder with
clean hot tap water and replace.
into the open position. Turn unit back ON ( I ) to continue
cleaning. Be sure your forward and backward strokes are done
at a slower pace.
8 0 0 . 2 3 7 . 7 6 9 1
8 0 0 . 2 3 7 . 7 6 9 1

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Proheat2x cleanshot 9500 serie

Tabla de contenido