Charging Directly From The Mains; Preparing The Room For A Cleaning Run; Using Your Robot; Starting And Stopping - Philips FC8932 Manual Del Usaurio

English
12
2
1

Preparing the room for a cleaning run

Using your robot

Starting and stopping

1 When the robot has finished cleaning or when only 15% of the battery
power remains, it automatically searches for the docking station to
recharge. When the robot searches for the docking station, the light in the
start/stop button turns orange.
2 When the rechargeable battery is fully charged, the start/stop button
lights up continuously.
Note: The robot only searches for the docking station automatically when it
started cleaning from the docking station.

Charging directly from the mains

1 Press the power switch to switch on the robot.
2 Insert the small plug of the adapter into the socket on the robot (1). Insert
the adapter into a wall socket (2).
3 When the robot is connected to the mains correctly, the start/stop button
starts flashing slowly. This indicates that the robot is charging.
4 When the rechargeable battery is fully charged, the start/stop button
lights up continuously.
Note: After charging, remove the small plug from the socket on the robot
and remove the adapter from the wall socket. The robot does not start
cleaning when it is still connected to a wall socket.
Before you start the robot on its cleaning run, make sure that you remove all
loose and fragile objects from the floor. Also remove all cables, wires and
cords from the floor.
You can also operate your robot with the remote control (FC8932 only) or
with the buttons on the user interface of the robot.
1 Set the power switch on the side of the robot to the 'on' position.
2 Press the start/stop button.