Removing The Tag From The Remote Control; Preparing For Use; Installing The Docking Station - Philips FC8820 Manual Del Usaurio

Removing the tag from the remote control

Preparing for use

Installing the docking station

2
1
1 0 0
c m
3 0
c m
The remote control works on a CR
protected with a protection tag that has to be removed before use.
Pull the battery protection tag out of the battery compartment of the
remote control. Now the remote control is ready for use.
Insert the small plug of the adapter into the socket on the docking station
and insert the adapter into the wall socket
-
The display of the docking station comes on.
Place the docking station on a horizontal, level floor against the wall.
Note: Make sure that there are no obstacles or height differences
in front, cm to the right and
Tip: To ensure the docking station stays firmly in the selected spot, fasten
it to the wall with screws or with two strips of double-sided tape.
coin-shaped battery. This battery is
.
cm to the left of the docking station.
English
cm