Overload Indicator Light (Red); Ac Pilot Light (Green) - Echo EGi-1200 Manual Del Operador

CONTROL FUNCTION

4.3 Overload indicator light (red)

The overload indicator light (1) comes on when an overload of a connected
electrical device is detected, the inverter control unit overheats, or the
AC output voltage rises. Then, the AC protector will trip, stopping power
generation in order to protect the generator and any connected electric
devices. The AC pilot light (Green) will go off and the overload indicator light
(Red) will stay on, but the engine will not stop running.
When the overload indicator light comes on and power generation stops,
proceed as follows:
1. Turn off any connected electric devices and stop the engine.
2. Reduce the total wattage of connected electric devices within the rated
output.
3. Check for blockages in the cooling air inlet and around the control unit. If
any blockages are found, remove.
4. After checking, restart the engine.
TIP: The overload indicator light may come on for a few seconds at first
when using electric devices that require a large starting current, such as a
compressor or a submergible pump. However, this is not a malfunction.

4.4 AC pilot light (green)

The AC pilot light (1) comes on when the engine starts and produces power.
11