Engine; Troubleshooting; Engine Won't Start; Generator Won't Produce Power - Echo EGi-1200 Manual Del Operador

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8. Install the cover and tighten the screws.
9. Turn the fuel tank cap air vent knob to "OFF" after the engine has
completely cooled down.

8.2 Engine

Perform the following steps to protect the cylinder, piston ring, etc. from
corrosion.
1. Remove the spark plug, pour about one tablespoon of SAE 10W-30 into
the spark plug hole and reinstall the spark plug. Recoil start the engine by
turning over several times (with 3-in-1 switch knob off) to coat the cylinder
walls with oil.
2. Pull the recoil starter until you feel compression. Then stop pulling. (This
prevents the cylinder and valves from rusting).
3. Clean exterior of the generator. Store the generator in a dry, well-ventilated
place, with the cover placed over it.

9. TROUBLESHOOTING

9.1 Engine won't start

1. Fuel systems
No fuel supplied to combustion chamber.
• No fuel in tank...Supply fuel.
• Fuel in tank....Fuel tank cap air vent knob and fuel cock knob to "ON"
• Clogged fuel filter .... Clean fuel filter.
• Clogged carburetor.... Clean carburetor.
2. Engine oil system
Insufficient
• Oil level is low.... Add engine oil.
3 . Electrical systems
• Put the 3-in-1 switch to "CHOKE" and pull the recoil starter ... Poor spark.
• Spark plug dirty with carbon or wet ... Remove carbon or wipe spark plug dry.
• Faulty ignition system ... consult our company authorized dealer.

9.2 Generator won't produce power

• Safety device (DC protector) to "OFF".... Press the DC protector to "ON".
• The AC pilot light (Green) goes off .... Stop the engine, then restart.
32
TROUBLESHOOTING

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido