Hoover XARION Manual De Instrucciones página 5

To access the exhaust filter:
1. Unlock the exhaust filter door by rotating the door along arrow indicated. [19]
2. Remove the filter pack from recess. [20]
3. Gently tap and wash the filter unit. Do not use hot water or detergents. Remove
excess water from the filter and leave to dry fully before reusing. [21]
4. Reassemble filter pack once fully dry and refit to the cleaner.
IMPORTANT: Do not use the product without the filter pack fitted.
Cleaning the Airvolution separation unit
This cleaner uses the Airvolution separation system, unique to Hoover. If necessary the
Airvolution separation unit can be removed from the dust container and cleaned.
1. Remove dust container from the cleaner by releasing the container carry handle to
detach the dust container from the main cleaner and pull upward to remove. [15]
2. Place the dust container on a flat surface and unclip the clips from either side of the
dust container. [22]
3. Using the dust container handle lift the dust container upper section containing the-
separation unit from the lower section. [23]
4. Use a cloth to remove excessive dust from the separation unit's surface. [24]
5. Reassemble the dust container upper section. Push clips back to fully close the dust
container. [25]
6. Refit the dust container to the cleaner. To lock in place push the container carry
handle down until the latch connects with the main body of the cleaner. Once cor-
rectly retained the carry handle will sit flush with the top of the cleaner.
Removing a blockage
1. Check if the dust container is full. If so refer to 'Emptying the dust container.
2. If the dust container is empty but suction is still low:
A. Do the filters need cleaning? If so refer to 'Cleaning the washable filters'.
B. Check if there is any other blockage in the system - Use a rod or pole to remove
any blockage from the extension tube or flexible hose.
C. Check if pre-motor filter is fitted and filter door is closed
D. Check if the cyclonic unit needs to be cleaned. Refer to 'Cleaning the cyclone
unit'
4800xxxx Xarion Pro Standard handle ML ef.indd 3
USER CHECKLIST
Should you have a problem with the product, complete this simple user checklist
before calling your local Hoover service.
• Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
• Is the cyclonic dust container over-filled? Please refer to 'Cleaner Maintenance'.
• Is the filter blocked? Please refer to 'Cleaner Maintenance'.
• Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the
system'.
• Has the cleaner overheated? If so, it will take approximately 30 minutes to auto-
matically reset.
IMPORTANT INFORMATION
Hoover spares and Consumables
Always replace parts with genuine Hoover spares. These are available from your lo-
cal Hoover dealer or direct from Hoover. When ordering parts always quote your model
number.
Consumables:
• Hepa Pre-Motor Filter: S104 - 35600990
• Hepa Exhaust Filter Door: T101 - 35600991
Hoover Service
Should you require service, spares and consumables at any time, please contact your
local Hoover Service Office.
Quality
BSI ISO 9001
Hoover's factories have been independently assessed for quality. Our products are
made using a quality system which meets the requirements of ISO 9001
3
GB
(*Certain Models Only)
25/01/2011 10:36:28