Specific Safety Instructions - Ferm SSM1005 Traducción Del Manual Original

EN
Features
Fig.A
1. On/off switch
2. Locking nut
3. Cross guide
4. Saw blade holder
5. Protective cover
6. Spanner
7. Dust blow pipe
8. Rubber feet
2. SAFETY INSTRUCTIONS
Explanation of the symbols
Denotes risk of personal injury, loss of life or damage to the tool in case of non-observance of
the instructions in this manual.
Denotes risk of electric shock.
Wear ear and eye protection

Specific safety instructions

• Wear safety goggles and a dust mask.
• This scroll saw machine is for indoor use only.
• Ensure that the teeth of the saw point downwards prior to using the machine.
• If teeth of the saw blade are missing or are damaged, then the saw blade must be replaced
immediately.
• Use the scroll saw machine on a stable and flat surface.
• Never exert pressure on the sides of the saw blade because it may break.
• Check wooden work pieces for possible protruding nails etc. and remove these.
• Do not touch the sawing surface with your hands.
• Never leave the sawing machine unattended while it is running.
• Do not remove any wood debris etc, in the vicinity of the saw with your hands while it is running. Turn
the machine off before removing the wood debris.
Immediately switch off the machine when
• Interruption in the mains plug, mains lead or mains lead damage.
• Defect switch.
• Smoke or stench of scorched isolation.
Electrical safety
When using electric machines always observe the safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal injury. Read the following safety instructions and also
the enclosed safety instructions.
Always check that the power supply corresponds to the voltage on the rating plate.
6 Ferm