Tool Operation - Bollhoff RQ P1000 Manual Del Usuario

EXE P1000 2000 3000 6-05:48 PAGES
2. Description of the tool

2.5. Tool operation

Riveting with blind rivets of different diameters requires use of appropriate nose-pieces that are located
in the spanner (accessories casing of the tool).
1) Replacement of nose-pieces:
Connect the tool to the source of compressed air, depress the trigger and screw out the nose-piece
from nozzle pos.9 with the spanner. Screw on a new nose-piece /acc. to the chart/ and tighten it. Now you
can release the trigger of the tool.
2) Multifunction trigger enables following:
a) Rotational movement of the trigger around the pin – riveting.
b) Vertical movement of the trigger – switching off the suction.
6/05/14 11:34 Page 25
• The trigger is on the front extreme position, not pressed.
• Depressing the trigger will set the rivet.
• Press and lock the trigger (after pressing shift it up 1,5 mm), then release
the trigger, the suction is switched off.
• Unlock the trigger (shifting the trigger down to the stop) and release it.
The suction is switched on and the trigger is in position "ready to set".
23
24