Bollhoff RQ P1000 Manual Del Usuario página 24

EXE P1000 2000 3000 6-05:48 PAGES
2. Description of the tool
3) Mandrel container
The tool can be operated in the following manners:
1) with the mandrel container removed in position 0:
Suction switches off by turning and removing the mandrel container.
Insert BR into the riveting tool through the nose-piece hole. Depress the trigger to move the jaws offward
the BR head. The movement ends when reaching max. stroke, correct BR with respect for material
gauge shall tear off the shank (riveting) for one stroke of the tool. Releasing the trigger shall return the
jaws to initial position and released torn-off shank can be removed from the nose-piece by tilting the
tool.
2) with the mandrel container mounted in position 1:
Suction switches on by turning the mandrel container to position 1.
In this position the suction holds BR in the nose-piece which enables riveting in any position without
danger of BR falling out of the nose-piece of the tool. Depressing the trigger shall perform riveting.
Releasing the trigger shall transport the shank into the mandrel container. If the mandrel container is
full with shank to appx. 70%, it is necessary to remove and empty it in a specified manner (e.g. to a
prepared container). Overfilling of the mandrel container may result in failure of the riveting tool.
.
6/05/14 11:34 Page 26
a) Mounting the mandrel container:
Match the mandrel container line
according to the hydraulic body line
marked position 0, push into the ring relief
(pos.26) end-to-end, thus you depress the
arrestment element, and turn to position 1.
The mandrel container shall thus be in
place and The suction shall initiate in relative
position of the mandrel container with air
outlets and the ring relief ensures that the
outlet air pressure goes out in a suitable
direction (e.g. away from the operator of
the tool).
b )Removing the mandrel container:
Turn the mandrel container end-to-end to
position 0 and pull it out of the ring relief.
The suction shall thus switch off.