Yakima Q-TOWERS Manual Del Usuario página 10

Overview
Perform Safety Checks With Vehicle Doors Open.
CHECK EACH CLIP! Pull each clip
away from vehicle. PULL HARD!
Repeat twice. Clip should
not move on second pull.
Once installed, easy on easy off without tools.
REMOVING THE SYSTEM
unlock towers and open cam covers.
Lift rack up and off (do not disassemble).
1033430H-10/33
Prepare for Install towers
installation in front
CHECK EACH TOWER!
grip the bar inboard to
towers; push and pull
using only arm strength.
If any of the clips or Towers move, check gold slider
positions, and fine tune by tightening adjustment
posts gradually (step 21b). If there is still movement
after fine tuning, verify the m1 (front installation) or
m3 (rear installation).
Install towers
Perform saftey
in rear checks
YOU ARE
HERE
INSTALLING RACKS AGAIN
• Open cam covers.
• Clean roof and place towers at
m2 (for front installation) or m4 +
m2 position (for rear installation);
measure carefully.
• Make sure clips are seated
properly, then close cam covers
with firm resistance.
PERfORm SAfETY CHECkS ON ALL
TOWERS AND CLIPS AfTER EVERY
INSTALLATION! (Step 22)