Yakima Q-TOWERS Manual Del Usuario página 8

Apply vinyl pads to clips.
• Apply black vinyl pads wherever clip
touches vehicle paint. Be sure to
cover clip edges. Trim if necessary.
Assemble Q-Clips and
lock housings.
• Insert the correct clip through
the slits in clip holder.
• Insert lock housing through
holes in clip and clip holder.
Loosely attach cam covers.
DO NOT MOVE TOWERS! If you
bump the towers you'll need to go
back and reposition them.
• Open both driver's side and passenger side doors.
• Carefully thread adjustment post on to tower to
get the cover loosely attached (2 turns max).
• Repeat for other side.
• Carefully push the clip in place up
against the door frame. DO NOT
mOVE THE TOWERS.
• using the adjustment post, take
slack out of the system until the
cam cover closes easily while
holding the clip to the door frame.
DO NOT FULLY TIGHTEN.
• Repeat for other side.
Check your M2 (front) or M2 + M4 (rear)
again. Correct if needed (step 10 for front
installation)(step 16 for rear installation).
1033430H-8/33
• Place clip fastener
over lock housing to
secure assembly.