Yakima Q-TOWERS Manual Del Usuario página 7

Prepare for
Overview
Position Towers in rear.
• Clean vehicle roof where towers will set.
• Set the assembly on the roof.
Set measurement.
• use the combination of
m2 and m4 measurements
(from Clip Sheet).
• measure the shortest
distance from leading edge
of tower base to nearest
painted roofline corner.
• Once positioned DO NOT
mOVE.
FOR EXAMPLE:
Center rack on vehicle.
Center racks side to
side by measuring from
the door frame to tower
base. measuring points
and distances on both
sides must be equal.
1033430H-7/33
Install towers
installation in front
Install towers
in rear
YOU ARE
HERE
Tundra Tower Location
Perform safety
checks
REAR Of VEHICLE
Correct measurements
can be found in the Q
If your vehicle is not
M2 = 6"
listed or the clip sheet
+ + is not in the Q-Clip box
check yakima.com/
M4 = 32"
measurements, contact
your dealer or call 888-
= 38"
925-4621.
Clip box.