Calculation Of The Average Value - AgraTronix GMT-Grind Manual Del Operador

Operation
Press and release the TEST button
and the testing countdown will begin.
When the display reaches zero,
the result is ready and average
measurement is updated. The current
moisture measurement is on the
Figure 6.
left, and the average measurement
Reading
reading is on the right (see Figure 6).
on the
display.
After measuring, clean the test cell
using the wire brush that is included
with the GMT-Grind Grain Moisture
Tester kit (see Figure 7).
The cleaning of all grain from the
test cell is important, since the next
measurement may be inaccurate if
Figure 7.
the test cell is not cleaned properly!
Cleaning
the cell.
The tester will automatically turn off
when it is not in use.

CALCULATION OF THE AVERAGE VALUE

The GMT-Grind Grain Moisture Tester automatically calculates and displays
the average value of the last four measurements.
The average value is shown on the lower right hand corner of the display.
The current measurement value displays on the left.
For the first measurement, the average value will be the same as the current
measurement value. After the second measurement, the average value is
the average of the two measurements. When four or more measurements
have been made, the meter will always show the average of the last four
measurements.
The average measurement will remain in the memory after the meter is
turned off.
The average value is automatically reset when changing to a different grain.
10-4