DAITEM SH151AX 3 Manual De Instalación página 107

1. Perform the following programming sequence:
then
*
Press then # on the
control panel keypad
2. Keeping in mind the precautions outlined in the chapter entitled Choosing the best place to install
the detector, position the detector in the chosen location without fixing it in place.
3. Test the radio range with the control panel by pressing and holding down the programming key
Cfg2.
• Satisfactory link: the control panel issues the voice message Beep, test fire detector n° X" to
confirm,
• Unsatisfactory link: no voice message is issued. Move the detector closer to the control panel or
use a radio repeater relay.
4. Fix the detector in place following steps 1 to 4 in chapter 2.4 Installing the detector as a standalone
device.
5. Put the control panel back in user mode by entering:
installer code
6. Proceed to chapter 3. Testing the detector
10 s max.
Press and hold the Cfg2 key for 10 s until the control
panel responds
107
"beep, fire detector n° X"
GB