Installing The Detector As A Relay - DAITEM SH151AX 3 Manual De Instalación

2.7 Installing the detector as a relay

If the radio range between all the detectors is insufficient, one of the detectors can be programmed as
a relay. This means that it will re-transmit alarms received to all the other detectors.
IMPORTANT: a detector programmed as a relay only relays an alarm to the other detectors. To relay
an alarm from a detector to an alarm control panel, use a radio repeater relay (SH701AX).
Examples:
A. If an alarm is activated on detector 1, only
detector 2 and the control panel will be
triggered.
Detector 1
Detector 2
IMPORTANT
• It is possible to programme just one "relay" detector per network.
• To be programmed as a relay, the detector must first have been programmed for recognition by
the network.
Control panel
Radio range limit
111
B. Detector 2 is programmed as a relay.
If an alarm is activated on detector 1, the
detector retransmits the information to
detectors 3 and 4.
Detector 1 Control panel
Detector 2
GB
Detector 3
Detector 4