Electrical Connections - Fulgor Milano Sofia Instrucciones De Installación

)DFWRU\ &RQQHFWHG 3RZHU 6XSSO\ &RUG
Your range is equipped with a factory-connected
power cord. Cord must be connected to a grounded
120/240 volt or 120/208 volt range outlet. If no
RXWOHW LV DYDLODEOH KDYH RQH LQVWDOOHG E\ D TXDOL¿HG
electrician.
NEMA 14-50P Plug
NEMA 14-50R Receptacle
3RZHU 6XSSO\ &RUG .LW RU )OH[LEOH &RQGXLW
(for US only)
The user is responsible for connecting the power
supply cord to the connection block located behind
the back panel access cover.
This appliance may be connected by means
RI SHUPDQHQW ³KDUG ZLULQJ´ ÀH[LEOH DUPRUHG RU
nonmetallic shielded copper cable), or by means of
a power supply cord kit. Use only a power supply
cord kit rated at 125/250 volts minimum and marked
for use with ranges. Cord must have either 3 or 4
conductors. Terminals on end of wires must either be
closed loop or open-end spade lugs with upturned
ends.
Use a power supply cord kit rated at minimum 50A
that is marked for use with nominal 1-3/8 in (34.93
mm) diameter connection openings.
1) Disconnect power.
2) Remove the terminal block cover screws located
on the back of the range.

Electrical connections

NEMA 10-50P Plug
(for US only)
NEMA 10-50R Receptacle
(for US only)
3) Add strain relief if not provided.
NOTE: If necessary remove the knockout to
insert the strain relief.
3RZHU VXSSO\ FRUG VWUDLQ UHOLHI
• Assemble a UL listed strain relief in the opening.
UL listed strain relief.
‡ )HHG WKH SRZHU VXSSO\ FRUG RU ÀH[LEOH FRQGXLW
through the strain relief in the cord/conduit plate
on bottom of range. Allow enough slack to easily
attach the wiring to the terminal block.
• Tighten strain relief screw against the power supply
FRUG RU ÀH[LEOH FRQGXLW
Installation Manual
ENGLISH
11