Hot Water Function; Steam Function - Krups XP6010 Manual De Instrucciones

KR_ESPRESSO_XP6010_NAFTA_NC00023130-04 31/05/12 10:07 Page15

2. HOT WATER FUNCTION

The production of hot water is ideal for preparing tea, infusions or pre-heating a container.
n Check the water level in the tank.
n Make sure that the frothing nozzle is securely fitted to the adjustable spout.
n Check that the rotating control button is set to PENDING (
SELECTION button (h2) is at COFFEE/HOT WATER
n Switch the machine on by turning the START/STOP button to the right to the (I) setting.
n The ON and TEMPERATURE lights
n It is imperative that you wait until the TEMPERATURE light
n Place a cup or bowl under the adjustable spout and make sure it is correctly positioned.
n Turn the control button to HOT WATER
n The hot water flows through the spout.
n When the desired quantity of water is reached:
- Turn the rotating control button to PENDING (
- The pump stops immediately and the spout circuit is closed.
IMPORTANT
It is possible that some steam may be released from the water tank. This is completely normal.
n You can now use the water collected to prepare your hot drink.

3. STEAM FUNCTION

Steam production is ideal for making the milk froth used in milk drinks (cappuccino, latte machiatto, hot
chocolate, etc.).
n Check the water level in the tank.
n Make sure that the frothing nozzle is securely fitted to the adjustable spout.
n Check that the rotating control button is set to PENDING (
n Switch the machine on by turning the START/STOP button to the right to the (I) setting.
n The ON and TEMPERATURE lights
n Turn the TEMPERATURE SELECTION button (h2) to STEAM
IMPORTANT
For increased safety, the ESPRESSO function
SELECTION button (h2) is at STEAM
n It is imperative that you wait until the TEMPERATURE light
n Place a container or empty cup under the spout.
n Open the spout circuit by turning the control button to STEAM
that may be in the circuit (fig.5).
n Turn the control button back to the left to PENDING (
n Pour the milk into a container and plunge the frothing nozzle into the container without touching the
bottom to prevent blocking the steam flow.
Advice
For a better result, use refrigerated milk, a cold stainless steel container and measure approximately
20 to 30 ml of milk per drink.
.
will come on.
goes out.
(fig.5).
●
) to stop the flow of hot water (fig.6).
●
).
come on.
is blocked when the TEMPERATURE
or when the heating unit is too hot.
goes out.
●
) (fig.4).
●
) and that the TEMPERATURE
.
to dispense any remaining water
English
15