Krups CALVI XP344 Manual De Instrucciones página 10

„ „
When a fine white layer clouds your tank, follow the descaling process (see paragraph
DESCALING).
„ „
Do not use alcohol-based cleaning products or solvents.
„ „
After you have unplugged the appliance, regularly clean the grid through which the
water passes, as well as the watertight seal, using a damp sponge (26).
„ „
Clean using only a damp cloth without any detergent or scourer.
B. The filter holder
„ „
Using a damp cloth, clean the filter holder mount regularly in order to remove possible
coffee residues stuck to the surface (26).
„ „
In order to prolong the useful life of the watertight seal on the brewing head, do not put
the filter holder back in place if the coffee machine has not been used for extended
periods.
„ „
To remove any deposits that could block the flow of your 1 or 2 cup filter, you may use
a needle to clean the holes (32).
C. The drip tray
This must be emptied each time the appliance is used. If several espressos are prepared
consecutively, it is recommended that you empty it regularly (27-28) (approximately every
five cups). The presence of water is normal and is not a sign of leakage. If necessary, clean
the drip tray and the grid with water and a small amount of mild dishwashing liquid. Rinse
and dry.
D. The steam wand
„ „
Place a container containing water under the steam wand.
„ „
To produce steam, turn the selection button to the Preheat position (D1-3) (10).
„ „
The on/off light will flash again and then remain on. The appliance is now ready to
follow the steam cleaning cycle.
„ „
As soon as the light stays on, plunge the steam wand into the water without touching
the bottom of the container.
„ „
Turn the selection button to the steam position (D1-4) (24).
„ „
Turn on for 20 seconds.
„ „
After turning off the steam, quickly and carefully clean the steam wand using a damp
sponge (in order to remove any residue).
„ „
The end of the wand can be removed using the measuring scoop for a deeper clean.
Take care not to lose the watertight seal on this end piece (29).
„ „
Rinse it under the tap and then remove any residues using a damp sponge (30).
„ „
You can unblock the wand outlet using a needle.
„ „
Screw it back on using the measuring scoop, checking that the seal is still there, and
making sure that the end piece is screwed on correctly (31).
IMPORTANT!
Warning! Do not clean any parts of this appliance in a dishwasher.
8