Commissioning - Abicor Binzel M-Drive MFS-V3 Instructivo De Servicio

6 Commissioning

6 Commissioning
DANGER
Risk of injury due to unexpected start-up
The following instructions must be followed during all maintenance, servicing, assembly, disassembly, and repair work:
• Switch off the power source.
• Close off the compressed air supply.
• Close off the gas supply.
• Disconnect all electrical connections.
DANGER
Risk of injury
Safety switches on covers and protective devices are ineffective in manual mode.
• Greater concentration.
WARNING
Risk of crushing
Hands can be drawn in and crushed.
• Do not reach into moving wheels.
NOTICE
• Please take note of the following instructions:
 2 Safety on page EN-3
• The system may be installed and commissioned only by qualified personnel (in Germany, see TRBS 1203).
6.1 Installation
The M-Drive
can be attached both horizontally and vertically (e.g. directly above the wire drum).
The add-on consoles are not included in the scope of delivery and must be attached at the place of installation. The
appropriate mounting holes can be found in:
 Fig. 1 on page EN-5
NOTICE
• Ensure clear access to the control elements and connections.
• Select a location that allows a short and rectilinear wire feed.
• Protect the components against rain and direct sunlight.
• Prevent dust and other foreign substances from entering the system's cooling air stream.
• Only use the device in dry, clean and well-ventilated rooms.
EN - 8
M-Drive
BAL.0393.0 • 2018-08-14