Introduction - Cole-Parmer MICROPUMP 75211-10 Manual De Operación

The instructions in this manual are task oriented to allow easy access to the desired information. Figure 1 provides
summarized information on all controls to the Pump Drives. This manual contains complete information on installing
and setting up the Pump Drives, as well as operating and servicing at the user level. The following chart provides basic
information on models covered in this manual.
Drive Catalog Number
75211-10
75211-15
75211-60
75211-65
75211-62
75211-67
*AC voltages can be either 50 or 60 Hz.
The Pump Drives contain the pump drive motor and motor controls in one compact unit. MICROPUMP
are attached directly to the motor, which is accessible from the front panel. In addition, these drives incorporate the
following features:
• Ball bearing motor for continuous duty
• Have controlled start-up
• Speed control over a 100:1 range
• Pumps are magnetically coupled to motor
• Stackable
• IP22 rating per IEC 529
• Replaceable Motor Brushes
75211-60 and 75211-65 are supplied with a centrifugal pump attached.

INTRODUCTION

Output rpm
50 to 5000
(purchase pump head separately)
90 to 9000
90 to 9000
(purchase pump head separately)
1
Flow rate
2.5–5450 mL/min
0–7.0 gpm
(with provided pump head)
0–7.0 gpm
Power Requirement*
90 to 130V AC
200 to 260V AC
90 to 130V AC
200 to 260V AC
90 to 130V AC
200 to 260V AC
®
Pump Heads