Functional Description; Putting Into Operation En; Risk Of Injury - Abicor Binzel eBOX MFS-V3 Instructivo De Servicio

eBOX

5 Functional description

The eBOX control unit acts as the communication interface between the higher-level system control unit and
the MFS's wire drives (optional for a hot wire power source).
All the default target values required for the wire feed process (analog/digital or via field bus) are
forwarded to the drives via microprocessor-based motor control units.
All electronic components are installed in the metal housing. The power supply is provided via a separate
connecting cable. For the connection voltage and power consumption, see:
 3.1 Technical data on page EN-6
6 Putting into operation
Risk of injury due to unexpected start-up
The following instructions must be adhered to throughout all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close the compressed air supply.
• Close the gas supply.
• Disconnect the mains plug.

Risk of injury

Safety switches on covers and protective devices are ineffective in manual mode (only in connection with
M-Drive).
• Greater concentration.
NOTICE
• Please take note of the following instructions:
• The system may only be installed and put into operation by authorized personnel (in Germany see
Remove the transport protection before putting the system into operation for the first time.
 4.1.1 Removing the transport protection on page EN-8
Install the service software before putting the system into operation for the first time. To do this, please refer
to the information in the service software operating instructions BAL.0420.
DANGER
DANGER
 2 Safety on page EN-4
TRBS 1203).
5 Functional description
EN - 9