Ebox Us1 Power Supply For The Bus Module And Logic Circuit En; Internal Power Supply En - Abicor Binzel eBOX MFS-V3 Instructivo De Servicio

6 Putting into operation
6.1 Installation
Select an installation site with sufficient ventilation and clearance for the housing fan.
6.2 eBOX US1 power supply for the bus module and logic circuit
The eBOX's logic circuit is powered by an internal power supply unit by default.
6.2.1 Internal power supply
When using an internal power supply, configure the following jumper settings on the main PCB (4):
1 Set jumper (1) to on (bottom position), jumper (2) to on (left position) and jumper (3) to on (bottom
position).
Switch on the eBOX at the main switch Q1 (6).
1
6
1 J1, J2
2 J3, J4
Fig. 4 Internal power supply
EN - 10
5
3 J5, J6
4 Main PCB
2
5 Port US1/US2 X3
6 Main switch Q1
eBOX
3
4