Commissioning; Checking The Direction Of Rotation - SOMFY Sonesse Ultra 50 RTS Manual De Instrucciones

EN

2.3. CommIssIonIng

2.3.1. Pre-programming the rts control point
1) Switch on the power supply.
Λ V
2) Press the and
point at the same time: The motorised product moves
up and down (fast raising and lowering), and the RTS
control point is pre-programmed in the motor.

2.3.2. Checking the direction of rotation

Λ
1) Press the button on the RTS control point:
a) If the motorised product rises (a), the direction
of rotation is correct: Move onto the section
entitled "Setting the end limits".
b) If the motorised product lowers (b), the direction
of rotation is incorrect: Move onto the next step.
2) Press the my button on the RTS control point
until the motorised product moves up and down: The
direction of rotation has been modified.
Λ
3) Press the button on the RTS control point to
check the direction of rotation.
2.3.3. setting the end limits
the end limits can be set in any order.
1) Raise the motorised product to the desired position
Λ
by pressing the button.
V
2) Press the my and
the motorised product moves.
The upper end limit is memorised.
3) Press the my button when the motorised product
reaches the desired lowered position. If necessary,
adjust the position of the motorised product using the
Λ V
and buttons.
Λ
4) Press the my and
the motorised product moves.
The lower end limit is memorised. The motorised product rises and stops in the raised position.
2.3.4. Validation of the setting
To confirm the end limits, press the my button until
the motorised product moves up and down.
The end limits are programmed.
6
Images not contractually binding
buttons on the RTS control
buttons at the same time until
buttons at the same time until
1 2
1)
a
a
=
=
a
=
b
b
=
=
b
=
2)
1)
3)
Copyright © 2014 Somfy SAS. All rights reserved.
3)
2)
4)