Tips And Recommendations For Installation - SOMFY Sonesse Ultra 50 RTS Manual De Instrucciones

2.3.5. recording the rts control point
The motorisation is in programming mode:
-- Quickly press the PROG button on the RTS control
point to be programmed:
→The motorised product moves up and down: this
RTS control point is programmed in the motorisation.
If the motorisation is no longer in programming mode, repeat step 2.3.1 then perform
step 2.3.4.
2.3.6. adding/deleting somfy control points and sensors
Refer to the corresponding guide.

2.4. tIPs and reCommendatIons for InstallatIon

2.4.1. questions about the sonesse Ultra 50 rts?
Observations
The wiring is incorrect.
The motorised
product does not
The Motor is in thermal protection. Wait until the motor cools down.
operate.
The control point battery is weak.
The control point is not
compatible.
The control point used has not
been programmed into the motor.
The motorised
The motor wheel and the crown
product is noisy:
are not suitable for the tube.
The motorised product is com-
pressed between the brackets
The tube contains swarf and
screws.
The motorised
The end-limits of the motorised
product stop to soon
product drift.
or to late.
Copyright © 2014 Somfy SAS. All rights reserved.
Possible causes
Images not contractually binding
PROG.
Solutions
Check the wiring and modify it if
necessary.
Check whether the battery is weak and
replace it if necessary.
Check for compatibility and replace the
control point if necessary.
Use a programmed control point or
program this control point.
Replace the motor wheel and the crown
Increase the play between the brackets
Clean the roller tube.
Readjust the end-limits
EN
7