SOMFY Sonesse 50 RTS Manual De Instalacion Y Uso página 16

EN
2.3.4. Recording the RTS control point
The motorisation is in programming mode:
-- Quickly press the PROG button on the RTS control
point to be programmed:
→The motorised product moves up and down: this
RTS control point is programmed in the motorisation.
If the motorisation is no longer in programming mode, repeat Step 2.3.1 then perform
Step 2.3.4.
2.3.5. Re-setting the end limits
Readjusting the upper end limit
Λ
1) Press the button to bring the motorised
product to the end limit to be readjusted.
Λ
2) Press the and
until the motorised product moves up and down.
Λ V
3) Press the or
product to the new desired position.
4) To confirm the new end limit, press the my
button until the motorised product moves up and
down.
Readjusting the lower end limit
V
1) Press the button to bring the motorised
product to the end limit to be readjusted.
Λ
2) Press the and
until the motorised product moves up and down.
Λ V
3) Press the or
product to the new desired position.
4) To confirm the new end limit, press the my
button until the motorised product moves up and
down.
16
V
buttons at the same time
button to move the motorised
V
buttons at the same time
button to move the motorised
Images not contractually binding
PROG.
1)
3)
1)
3)
Copyright © 2014 Somfy SAS. All rights reserved.
2)
4)
2)
4)