Wiring - SOMFY Sonesse 50 RTS Manual De Instalacion Y Uso

EN
a
2.1.3. Drive/tube assembly
1) Slide the drive into the roller tube.
For roller tubes which are smooth inside, position the
notch previously cut on the boss on the crown.
2) The drive wheel must be locked in place to prevent it
moving along the roller tube:
• This can be done either by fixing the roller tube to the
drive wheel using 4 x Ø 5 mm self-tapping screws,
or by using 4 x Ø 4.8 mm steel pop rivets placed 5
mm to 15 mm from the outer rim of the drive wheel,
regardless of the roller tube.
The screws or pop rivets must only be attached to

the drive wheel and not to the drive.
• Alternatively, a drive wheel stop can be used for tubes which are not smooth.
2.1.4. Installing the drive/tube assembly
1) Install and fix the drive/tube assembly onto the end bracket f
and onto the drive bracket g:
Ensure that the drive/tube assembly is secured onto

the end bracket. This operation prevents the drive/
tube assembly from coming out of the end bracket
e
e h mounting when the roller blind reaches the lower end
limit position.
2) Depending on the type of bracket, fit the stop ring h in
place.
e h

2.2. WIRINg

Cables which pass through a metal wall must be protected and isolated using a sheath
or sleeve.
Attach cables to prevent any contact with moving parts.
The cable on the Sonesse 50 can be removed. If it is damaged, replace it with an identical
cable.

Leave the drive power supply cable accessible: it must be possible to replace it easily.

Always make a loop in the power supply cable to prevent water entering the drive!
Switch off the power supply.
-
Connect the drive according to the information in the table below:
-
230V-50Hz
220V-60Hz
120V-60Hz
14
b
b
a
Ø>47mm
Ø>47mm
h
e
h
Neutral Live
Blue Brown
White Black
Images not contractually binding
Earth
Yellow/
green
Green
Copyright © 2014 Somfy SAS. All rights reserved.
1)
2)
15 mm
L1
1)
g
2)
h
1
2
3
2
3 x 1,5 mm
5 mm
20 mm
f
2
3 x 0.75 mm